EasyManuals Logo

Worx WG543 User Manual

Worx WG543
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
20V Cordless Blower WG543 WG543.9
Air speed mode
NOTE: The blower is in the air speed
mode for default assembly.
NOTE: The blower has two working
modes: air speed mode and air volume
mode. To change modes, depress
the nozzle release button and slide
backward for air speed mode. Slide
forward for air volume mode.
Choose a suitable mode according
to your work. Air speed mode is
recommended for cleaning in grass,
as shown in Fig. H1. While air volume
mode is recommended for cleaning on
hard ground such as cement, as shown
in Fig. H2.
See Fig. D
Air volume mode
See Fig.
E, F
OPERATION
Starting & Stopping
WARNING!
The tool runs for a
few seconds after it has been
switched off.
Let the motor come to a complete
standstill before setting the tool down.
See Fig. G
Adjusting the blowing speed / air
volume with 2-speed switch
USER TIPS
- Hold the blower tube approximately
8” above the ground when operating
the tool.
Use a sweeping motion from side
to side. Advance slowly keeping the
accumulated debris/leaves in front of
you.
- After blowing the debris/leaves into a
pile, it is easy to dispose of the pile.
Caution!
- Do not blow hard objects such
as nails, bolts, or rocks.
- Do not operate the blower near
bystanders or pets.
- Use extra care when cleaning
debris from stairs or other tight
areas.
- Wear safety goggles or other
suitable eye protection, long
pants, and shoes.
See Fig.
H1, H2
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0 -45 (32 -
11 3 ).
The recommended ambient temperature range for
the charging system during charging is
0 -40 (32 -104 ).
CLEANING THE TOOL
Clean the tool regularly.
WARNING! Keep your product dry. Under
no circumstances spray with water.
- To clean the tool, use only mild soap and a
damp cloth.
- Do not use any type of detergent, cleaner
or solvent which may contain chemicals that
could seriously damage the plastic.
- Self lubricating bearings are used in your
product, therefore lubrication is not required.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Worx WG543 and is the answer not in the manual?

Worx WG543 Specifications

General IconGeneral
BrandWorx
ModelWG543
CategoryBlower
LanguageEnglish

Related product manuals