EasyManuals Logo

Worx WG591 User Manual

Worx WG591
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
9
Cordless Li-Ion Blower EN
OPERATION
INTENDED USE:
The blower is intended for residential use only. Use the blower outdoors to move yard debris as needed.
ASSEMBLY AND OPERATION
Action Figure
Assembling & disassembling the Blower Tube See Fig. A&B
Installing & Removing the Battery Pack.
NOTE: Depress the battery release button to release battery pack from your
tool. After recharging, insert the battery pack into tool’s battery port. A simple
push and slight pressure will be sufficient.
See Fig. C&D
Checking the battery charger condition
Your battery pack is UNCHARGED, you must charge before use.
See Fig. E
Charging the battery
More details can be found in WA3859’s manual
WARNING! The charger and battery pack are specially designed to work
together, so do not attempt to use any other devices. Never insert or allow
metallic objects into your charger or battery pack connections because of an
electrical failure and hazard will occur.
See Fig. F
Starting & Stopping
WARNING! The tool runs for a few seconds after it has been switched off.
Let the motor come to a complete standstill before setting the tool down.
See Fig. G
Blowing
USER TIPS
-
Hold the blow tube approximately 8” above the ground when operating the tool.
Use a sweeping motion from side to side. Advance slowly keeping the
accumulated debris/leaves in front of you.
- After blowing the debris/leaves into a pile, it is easy to dispose of the pile.
CAUTION!
- Do not blow hard objects such as nails, bolts, or rocks.
- Do not operate the blower near bystanders or pets.
- Use extra care when cleaning debris from stairs or other tight areas.
- Wear safety goggles or other suitable eye protection, long pants,
and shoes.
See Fig. H
CLEANING THE TOOL
Clean the tool regularly.
WARNING: Keep your product dry. Under no circumstances spray with water.
- To clean the tool, use only mild soap and a damp cloth.
- Do not use any type of detergent, cleaner or solvent which may contain chemicals
that could seriously damage the plastic.
-
Self lubricating bearings are used in your product, therefore lubrication is not required.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Worx WG591 and is the answer not in the manual?

Worx WG591 Specifications

General IconGeneral
BrandWorx
ModelWG591
CategoryBlower
LanguageEnglish

Related product manuals