Electric Pressure Washer EN
11
Cleaning
Begin with the nozzle 1-2ft away from
the surface and approach with caution
until it reaches the desired position
for overly close spray may do harm to
surface.
WARNING: Do not connect the
machine to water supplies that
are dirty, rusty, muddy, or corrosive.
(Including window cleaning liquids,
plant foods, or fertilizers etc.)
See Fig. K
Add and use detergent
Install the soap nozzle before opera-
tion.
NOTE If necessary, use a funnel (not
supplied)to prevent accidental over-
flows of detergent outside of the tank.
See Fig. L1,
L2, L3
Using the power cord holder
To wind the power cord, turn the hold-
ers outwards. To unwind the hose, turn
the holders inwards.
See Fig. M1,
M2
MAINTENANCE
Remove plug from the socket before carrying out
any adjustment, servicing or maintenance.
Inspect the product for damaged or worn parts before each
use. Do not operate it if you find damaged or worn parts.
Contact your supplier or the manufacturer for replacement
parts.
Power cord maintenance
If the electrical cord is damaged, do not attempt to repair
yourself; call the Worx solutions center for further assistance.
Pump maintenance
Inspect the pump frequently whether any leaking occurs
around the pump seal. If leaking occurs, please contact the
solutions center for further assistance.
Nozzle maintenance
Remove the nozzle from the lance, then remove any possible
obstructions using the included declogging needle (See
Fig. O).Then use a garden hose to rinse the nozzle by
backwashing.
WARNING
Any other servicing should be
performed by an authorized service representa-
tive.
STORAGE
1. Disconnect the water source. Turn on the pressure
washer for a few seconds until the remaining water flows
out. Then turn it off quickly.
2. Unplug the power supply and wind power cord on the
tool. (See Fig. M1)
3. Disconnect the high pressure hose and the garden hose
(not supplied) .Then wind high pressure hose. (See Fig.
P1) Insert the Wand and lance separately into the Wand
Holder and lance holder. (See Fig. P2)
4. Store in a frost free area with a temperature above
0
°C
(32
°
F).
TROUBLESHOOTING
Symptom Possible causes Solution
Machine does not start
when the switch is in”
I”position.
Power cord is not plugged in. Plug in power cord.
Socket is defective
.
Check or replace plug, socket, fuses.
GFCI is triggered. Press reset on GFCI plug.
Machine pressure is
not consistent.
Pump is faulty. Contact service center .
Air in line. Remove the nozzle, turn on the machine for a while and
install the nozzle back.
Water inlet adapter is clogged or dirty. Remove the adapter, rinse it with water and put is back.
The pressure of the
pump is not adequate
Water supply is Insufficient. Open water source completely.
Water supply is restricted. Check If the water hose kinks or leaks.
Diameter of garden hose is too small. Replace with right garden hose .
Leak or kick in hose . Replace hose or untie kinks in hose.
No detergent Wrong nozzle is attached Attach the soap nozzle
Lance leaks O-ring needs to be replaced. (See
Fig. B1)
Replace O-ring .If the problem is not solved ,contact
service center to buy a new lance.
To Next Page
Loading...