Worx WX641 User Manual

9
Finishing Sander EN
To reduce the risk of injury, user
must read instruction manual
Double insulation
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Waste electrical products must not
be disposed of with household
waste. Please recycle where
facilities exist. Check with your local
authorities or retailer for recycling
advice.
SYMBOLS
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for dry sanding of
wood, plastic, filler and coated surfaces.
ASSEMBLY AND OPERATION
Action Figure
ASSEMBLY
Fitting &Removing the
Sanding Paper
See Fig. A1, A2
Paper Punch (Optional) See Fig. B
Attaching the Dust Box
Caution: To prevent
the possibility of
sanding dust or foreign
body being thrown into
your face or eyes, never
attempt to use your
sander without the dust
box properly installed.
See Fig. C
Emptying the Dust Box
-For more efficient
operation, empty dusts
box every 5-10mins.
See Fig. D1, D2
Using the Dust Extraction
Adapter
See Fig. E, F
OPERATION
Plugging in the power See Fig. G
Switching On/Off See Fig. H
Variable speed control
(only for WX642)
See Fig. I
WORKING HINTS FOR YOUR
FINISHING SANDER
If your power tool becomes too hot, especially
when used at low speed, set the speed to
maximum and run it with no load for 2-3 minutes
to cool the motor. Avoid prolonged usage at
very low speeds. Always use sand paper that is
suitable for the material you want to sand.
Always ensure the work-piece is firmly held or

Worx WX641 Specifications

General

Product color	Black
Type of sander	-
Power	250 W
Maximum paper size	93 x 230 mm
Idle oscillation rate (max)	12000 OPM
Number of sandpapers	6
Power source	AC

Weight and Dimensions

Weight	2000 g
Sanding plate size (WxD)	90 x 187 mm