WORKING HINTS FOR YOUR
BELT SANDER
If your power tool becomes too hot, especially
when used at low speed, set the speed to
maximum and run with no load for 2-3
minutes to cool the motor. Avoid prolonged
usage at very low speed. Always use a
sanding belt suited to the material you wish
to sand. Always ensure the work-piece
is firmly held or clamped to prevent
movement. Support large panels close to
the sanding area. Any movement of the
material may affect the quality of the sanding
finish. Start your sander before sanding and
turn off only after stopping sanding. For
best results sand wood in the direction of
the grain. Do not start sanding without the
sanding belt fitted. Empty the dust bag every 5
minutes or sooner to ensure efficient dust
collection.
MAINTAINANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional
lubrication or maintenance. There are no
user serviceable parts in your power tool.
Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry
cloth. Always store your power tool in a dry
place. Keep the motor ventilation slots clean.
Keep all working controls free of dust.
Occasionally you may see sparks through
the ventilation slots. This is normal. If the
supply cord is damaged, it must be replaced
by the manufacturer, its service agent or
similarly qualified persons in order to avoid a
hazard.
ENVIRONMENTAL
PROTECTION
This product has been marked with a
symbol relating to removing electric
and electronic waste. This means that
this product shall not be discarded with
household waste but that it shall be returned
to a collection system which conforms to the
European Directive 2002/96/CE. It will then
be recycled or dismantled in order to reduce
the impact on the environment. Electric and
electronic equipment can be hazardous for the
environment and for human health since they
contain hazardous substances.
To Next Page
Loading...
Need help?
General
