TECHNICAL DATA
Type WX661 WX661.1(660-669-designation of machinery, representative of belt
sander)
Rated voltage 220-240V~50Hz
Rated power 950W
Rated no load speed 240-350m/min
Belt size 76mmx533mm
Sanding area 76mmx130mm
Protection class
/II
Machine weight 3.3kg
NOISE AND VIBRATION DATA
A weighted sound pressure 86.5dB(A)
A weighted sound power 97.5dB(A)
K
PA
&K
WA
3.0dB(A)
Wear ear protection when sound pressure is over 80dB(A)
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined according to EN 60745:
Typical weighted vibration
Vibration emission value a
h
= 9.2m/s
2
Uncertainty K = 1.5m/s²
WARNING: The vibration emission value during actual use of the power tool can differ
from the declared value depending on the ways in which the tool is used dependant on the
following examples and other variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
The use the correct accessory for the tool and ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti vibration accessories are used.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand-arm vibration syndrome if its use is not adequately
managed.
WARNING: To be accurate, an estimation of exposure level in the actual conditions of use
should also take account of all parts of the operating cycle such as the times when the tool
is switched off and when it is running idle but not actually doing the job. This may significantly
To Next Page
Loading...
Need help?
General
