9
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The power tool is intended for sawing and
remodelling wooden materials, plastic,
plaster, non-ferrous metals and fasteners (e.g.
nails and clamps) as well as for working on
soft wall tiles and for dry grinding of small
surfaces. It is especially suitable for working
close to edges and for flush cutting.
ASSEMBLY AND OPERATION
Action Figure
Mounting accessories See Fig. A-C
Mounting the sanding
sheet
See Fig. D
Mounting the suction
device (not supplied)
See Fig. E1-E5
Operating the on/off
switch
See Fig. F
Using the variable speed
dial
See Fig.G
The Variable Speed Dial can be used to set
the optimum oscillating frequency according
to the accessories used and the respective
application.
Oscillation
Frequency
Application
High oscillation
frequency
Sanding, sawing,
rasping and
polishing stone and
metal.
Low oscillation
frequency
Scraping, polishing
varnishes.
High oscillation frequency
Low oscillation frequency
Waste electrical products must not
be disposed of with household
waste. Please recycle where
facilities exist. Check with your
local authorities or retailer for
recycling advice.
To Next Page
Loading...
Need help?
General
