DigiReader Series
P/N 6600025, REV. BX 7
ERUTCAFUNAM
LACISYHP
NOITPIRCSED
EGUAG
.tF0004<rewoPdnaataD
elbaC&eriWtsewhtuoS
yarG/971WS
ataD:rotcudnoC2
rewoP:rotcudnoC2
GWA22
GWA61
.tF005<rewoPdnaataD
2559nedleB
9601nedleB
dedleihSriaP-2
GWA81
GWA61
.tF005>ylnOataD1489nedleBdedleihSriaP-1GWA42
.tF005>ylnOrewoP
1439nedleB
2431nedleB
3439nedleB
rotcudnoC2
GWA81
GWA61
GWA41
RECOMMENDED S-NET CABLE
The type of cable used for the S-Net will depend on the total length and the number of devices
connected. Table 5 lists WSE recommended cables.
Table 5: Recommended S-Net Cable
SWITCHES
There are two switches on most DR4200 Series DigiReader printed circuit board, as follows,
(refer to Figure 2):
Switch SW1 is used to select between the S-Net or Wiegand operating modes.
Switch SW2 is used to set the S-Net address.
The DR4201 reader has a 5-position DIP-switch S1, which combines the functions of the rotary
address switches S1 and S2 used by the other DR4200 Series DigiReaders. This is described in
the DR4201 ADDRESS DIP-SWITCH section, below.
To Next Page
Loading...