DXU4QdQ5^dbi@Q^U\45@
!( =_TYVYUT*( ! % ! DUSX^Ydb_^D" % GU \T3_^db_\
!!@b_WbQ]
]_TURedd_^
No sequence or config instructions can be changed unless the
control is in Program mode. In this mode, the control will NOT
run. If you try to change sequence or configuration items when
not in Program mode, the letters LOC appear in the numeric
display.
!"61E<D
B5C5DRedd_^
This button resets the fault currently displayed on the numeric
display. It may be necessary to press this button more than once
to clear multiple faults.
To Next Page
Loading...
