To Next PageTo Next Page
Need help?Do you have a question about the WTC Technitron T2050 and is the answer not in the manual?
Overview of the Technitron T2050 weld control system and its capabilities.
Details the seven inputs and six outputs of the control system.
Highlights key connectors, DIP switches, and hardware I/O points on the controller board.
Explains virtual and physical DIP switches for configuring control features.
Describes the function of bits within the Option Flag.
Explains the function of DIP switch 1 for Constant Current or AVC mode selection.
Explains the function of DIP switch 2 for binary input selection.
Explains DIP 3 function for V1.01 firmware: Pressure Switch or Second Stage.
Explains DIP 3 function for V1.01A firmware: Reset Steppers or Second Stage.
Step-by-step guide for connecting the T2050 control system.
Crucial warnings and operational hints for initial setup and operation.
Details the sequence of instructions in a weld schedule and their parameters.
Procedure for calibrating line voltage and current settings.
Describes specific fault conditions: ESTOP, Contactor, Over Temp, Half Cycle, Compensation.
Step-by-step guide to calibrate primary current.
Step-by-step guide to calibrate secondary current.
Step-by-step guide to calibrate line voltage.
Demonstrates setting up a successive welding application with multiple welds.
General| Brand | WTC |
|---|---|
| Model | Technitron T2050 |
| Category | Control Unit |
| Language | English |
