WTC Technitron T2050 - Control Fault Codes

6Qe\dcQ^T=UccQWUc
#$ =_TYVYUT*' ! ! ! DUSX^Ydb_^D" % GU \T3_^db_\
&RQWURO)DXOWV S_1 Stepper 1 program ended
S_2 Stepper 2 program ended
S_3 Stepper 3 program ended
S_4 Stepper 4 program ended
E_S Emergency Stop
C_F Contactor Fault
O_F SCR Overtemp
H_F Half Cycling Fault
ErH Data out of range – Error High
ErL Data out of range – Error Low
Err System Error
LC Line clock missing
HI Compensation over 99%
LO Compensation under 20%
2WKHU6WDWXV
0HVVDJHV
PIL The pilot is not clear at off single. Remove the pilot or
press RESET (anti-repeat).
ES Stepper reset acknowledged, momentarily displayed.
? Accept calibration value change? (If yes, press FAULT
RESET.)
LOC Locked out, or not in program mode
S_S Second Stage Open, close to latch in sequence
P_S Pressure Switch Open, close to continue sequence
CLr Memory has been cleared (except Calibration Data)
PrS Program in Sequence was reset
SCH Reset of Successive Schedules has been accomplished
P_C The Part counter equals the counter’s programmed
value