WTI DSM-40 - The Emergency Shutoff Alarm (CPM Series Units Only)

9-28
Alarm Configuration
9.10. The Emergency Shutoff Alarm (CPM Series Units Only)
The Emergency Shutoff Alarm can provide notification when the CPM's Emergency
Shutoff feature is triggered.
Notes:
• TheEmergencyShutoffAlarmisonlyavailableonCPMSeriesunits.
• InorderfortheCPMtoprovidealarmnotificationviaEmail,communication
parametersmustfirstbedefinedasdescribedinSection6.8.11.
• InorderfortheCPMtoprovidealarmnotificationviaSyslogMessage,Syslog
parametersmustfirstbedefinedandSyslogMessagesmustbeenabledas
describedinSection6.8.2andSection11.
• InorderfortheCPMtoprovidealarmnotificationviaSNMPTrap,SNMP
parametersmustfirstbedefined,andSNMPTrapsmustbeenabledas
describedinSection6.8.7andSection12.
To configure the Emergency Shutoff Alarm, you must access the CPM command mode
using a password that permits Administrator Level commands. The Lost Voltage Alarm
Configuration menu offers the following parameters:
• TriggerEnable: Enables/Disables the trigger for this alarm. When Disabled, this
alarm will be suppressed. (Default = On)
Note:
• Tocancelanalarmwithoutcorrectingtheconditionthatcausedthealarm,
simplytoggletheTriggerEnableparameterOffandthenbackOnagain.
• TheTriggerEnable,NotifyUponClear,EmailMessageandAddress1,2
and3Parametersallinclude"CopytoAllTriggers"optionsthatallowyouto
enable/disablethecorrespondingparameterforallDSM/CPMalarms.For
example,iftheLostVoltageAlarm'sTriggerEnableparameterissetto"On
(CopytoAllTriggers),thenallotherDSM/CPMalarmswillalsobeenabled.
• ResendDelay: Determines how long the CPM will wait to resend an email
message generated by this alarm, when the initial attempt to send the notification
was unsuccessful. (Default = 60 Minutes)
• NotifyUponClear: When enabled, the CPM will send additional notification when
the situation that caused the alarm has been corrected. For example, when Notify
Upon Clear is enabled, the CPM will send initial notification when it detects that the
Emergency Shutoff function is initiated, and then send a second notification when
the unit determines that power has been restored. (Default = On)