ii
Warnings and Cautions
Disconnect Power
If any of the following events are noted, immediately disconnect the unit from the outlet
and contact qualified service personnel:
1. If the power cord becomes frayed or damaged.
2. If liquid has been spilled into the device or if the device has been exposed to rain
or water.
Disconnect Power Before Servicing
Before attempting to service or remove this unit, please make certain to disconnect the
power supply cable(s) from the power source(s).
Up to Four Power Supply Cables
Note that some DSM series units feature two separate power inlets and a separate
power supply cable for each power inlet.
In addition, some CPM-1600 series units feature four separate power inlets and a
separate power supply cable for each power inlet. Make certain to disconnect all power
supply cables from their power source before attempting to service or remove the unit.
Modem Cables
CAUTION: To reduce the risk of fire, use only No. 26 AWG or larger (e.g., 24 AWG) UL
Listed or CSA Certified Telecommunication Line Cord.
ATTENTION: Pour réduire les risques d’incendie, utiliser uniquement des conducteurs
de télécommunications 26 AWG au de section supérieure.
Restricted Access (CPM Series Only)
CPM Series units are intended for installation in Restricted Access Location.
Les matériels sont destinés à être installés dans des EMPLACEMENTS À ACCÈS
RESTREINT.
To Next Page
