Assembly inside the Tool Holder
• Before assembling the CoolSpeed mini inside the tool holder, make sure that the CoolSpeed mini is fully assembled,
including rear cover and front cover (Tool Assembly is not mandatory).
• The front cover helps to define the CoolSpeed mini position in relation to the tool holder.
• Before assembly, clean the tool holder internal and external diameter. Pay attention to corrosion marks upon the Tool
Holder, and CoolSpeed mini. Remove any corrosion marks.
• Before assembly, pay attention to the CoolSpeed mini Jet’s. Assure they are all clean and open. Clean the Jet’s with a
small needle if necessary (1.4 mm – 0.055 in)
• In case of CoolSpeed mini Air, pay attention to the external O-Ring seal. Change the O-Ring if necessary.
• Use moderated torque to close the CoolSpeed mini inside the Tool Holder. The Torque should be according to the Tool
Holder manufacture. In case of Low torque, the CoolSpeed mini might disconnect from the Tool Holder due to the high
pressure. Therefore it is extremely important (safety issues) to apply the minimum require torque.
• Extensive Torque (Radial force) upon the CoolSpeed mini might cause radial distortion of the CoolSpeed mini housing.
Therefore, it is important to apply clamping force according Tool Holder recommendations as function of hydraulic
pressure.
• In order to avoid damage to the machine or human injuries, it is mandatory to apply the pressure (emulsion, oil and air)
right after the CoolSpeed mini assembly (inside the Tool Holder) while the CoolSpeed mini is blocked by the machine
horizontal table. In case of wrong torque (too low) the CoolSpeed mini will get out of the Tool holder and be blocked by
the horizontal table.
• In case of replacement kit change, it is not necessary to remove the CoolSpeed mini out of the Tool Holder, just open the
front cover and pull out the tool.
To Next Page
Loading...
