2. Installation
Please remove the insulation plate before
using.
1
2
3
3. Operation
ON/OFF: Click on switch to turn on the flashlight, click again to turn it off. The flashlight
has memory function, will memorize default output selections, but not flash modes.
Output Selections: When the flashlight is on, long press switch to cycle through Moon
-Low-Med-High-Moon.It will lockout the brightness once releasing the switch at any modes.
Continuous Output Selections: When the light is off, long press switch to activate Moon
mode, after holding for 2 seconds, the brightness starts to rise slowly, flashes once after
reaching the highest mode, then slowly descends, and then flashes to the lowest mode.
Release the switch to select your desired brightness, single click to exit.
- 07 -
E
N