WUNDER RS300 - ELECTROMAGNETIC COMPATIBILITY

WUNDER SA.BI.SRL EN USER MANUAL
RS 300 REV.01 10/01/2017 4
-When using electrical components under increased safety requirements, always comply with the
appropriate regulations.
- Improper installation will render the warranty null and void.
- Ensure the voltage marked on the power supply unit matches your mains power supply.
- This device is designed for use indoors.
- Observe the permissible ambient temperatures for use
- The device meets the requirements for electromagnetic compatibility. Do not exceed the maximum values
specified in the applicable standards.
- Ensure that the patient does not lean against the device risk of falling! If you have any problem, contact
your local service partner.
-The maximum scale loading must not be exceded. The device beeps when loading exceeds its maximum
capacity.
3.1 Manufacturer's guide and declaration – electromagnetic immunity
Guide and Statement of manufacturer – Electromagnetic emissions
The electronic scales RS300 model is scheduled for operation in the electromagnetic environment specified
below.
the customer and the user should ensure that it is used in that environment
Emission test
Conformity
Guide to electromagnetic environment
RF Emission CISPR11
Group 1 Class B
The scales RS300 cable model uses RF energy only for its
internal function. The refore its RF emissions are very low and
probably not cause no interference in electrical equipment.
RF Emission CISPR11
Group 1, Class B
The scales RS300 is suitable for use in all sanitary and hospital
buildings, connected to the low voltage public power supply
network.
Harmonic emission
Class A
Voltage fluctuations/
flicker emission
Compliant
Guide and Statement of manufacturer-Electromagnetic Immunity
The electronic scales RS300 model is scheduled for operation in the electromagnetic environment
specified below.
the customer and the user should ensure that it is used in that environment.
Immunity test
Compliance
Guide to electromagnetic environment
Electrostatic
discharges (ESD)
IEC/EN61000 - 4 -2
6kV in contact
8kV in air
The floors should be made of wood, concrete or ceramic. If
the floors are covered in synthetic material, the relative
humidity should be maximum 30%.
Rapid
transients/burst
2kV power supply
The power supply should be of the type used typically in
commercial or hospital environments.