1. ON/OFF/ZERO/TARE:
1. Switch on/off the scale
2. Press this key to zero the scale. The zero range is +/- 2% of full capacity.
3. Press this key to tare when loads over zero range.
4. In tare mode, press this key again to clear the tarred value when there is no load on the platform.
5. Press this key without release 3 seconds to power off the scale.
2. HOLD:Press this key to lock weight value while weighing. Disable the hold function, press Hold key again.
3. NET :”Net” function indicator
4. HOLD:”Hold” function indicator