Wunderwiege WUWI - Hooking the springs into the motor

2
Now you can hook the
springs into the positions
you determined on page 46.
To do this, rst slip
the round end of the spring
over the corresponding
hole in the ring by slightly
prying apart the opening
of the spring, either with
your ngernail or with the
spring opener included in
the package. As soon as the
end tip of the opened spring
is above the hole, you can
make the spring hook in
place with a twisting motion
and a slight upward pull.
Here you can see again how
it works:
FRONT
or
48
EN