Wyebot WIS4 00 Series

To Next Page

WIS4200/WIS4300 (WIS4x00) Quick Start Guide

Location

For optimal performance with a particular access point, the WIS4x00 should be located

between 3-6 feet from the access point.! The unit

may be mounted on a wall, ceiling or above the

ceiling.

Wall Mounting

Download a full-size printable version of the

template and instructions from!

http://support.wyebot.com/help/Wyebot-WIS4x00-

wallmount-template.pdf

Suspended Ceiling Mount

Select the pair of ceiling rail clips which match the

width of your ceilings T-bar rails.! The provided

clips support both 9/16” and 15/16” ceiling rails.

Using the two 8mm lock screws provided, attach the respective clips to the bottom of the

WIS4x00.! Ensure clips are aligned with the indented areas on the bottom of the WIS4x00 (See

Fig. 1).

Attach the WIS4x00 to a secure ceiling rail by attaching one clip at a time to the rail (See Fig. 2).

Verify the WIS4x00 ﬁts securely on the ceiling tile rail for the most secure mounting.!

NOTE: the included wall anchors are NOT

suitable for use in a drywall ceiling.! Toggle

bolts or other anchors intended for ceilings

and capable of supporting 5lbs or more should

be purchased separately.

Above Ceiling (Plenum Space)

The WIS4x00 is suitable for use in

environmental air space in accordance with

Section 300-22(C) of the National Electrical

Code.! Use above a suspended ceiling is

permitted in a horizontal mounting position

only.! The optimal orientation of the unit is with

the top cover (logo) facing down toward the ﬂoor.! Avoid placing the unit near electrical wiring

or ductwork in order to reduce the impact these items may have on RF signals.

support@wyebot.com 2020 Wyebot, Inc. WIS4x00 Quick Start Guide

Need help?

Do you have a question about the Wyebot WIS4 00 Series and is the answer not in the manual?

Summary

Device Location and Mounting

Wall Mounting

Download a full-size printable version of the template and instructions from the provided URL for wall mounting.

Suspended Ceiling Mount

Select ceiling rail clips for T-bar rails (9/16" or 15/16"), attach to WIS4x00, and secure to ceiling rail. Use appropriate anchors for drywall ceilings.

Above Ceiling Installation

Suitable for environmental air space (plenum). Horizontal mounting is permitted, with the logo facing down. Avoid proximity to wiring or ductwork.

Unit Setup and Connectivity

Powering the Unit

Power the WIS4x00 using PoE (802.3at for WIS4300) via the '1G/PoE' port or an optional AC/DC adapter via the '12VDC' port.

Network Configuration

The WIS4x00 is a plug-and-play solution; it defaults to DHCP on Ethernet to obtain an IP address.

Connecting to the Cloud

Connect the Sensor to a PoE port. Wait for the Cloud LED to turn solid green and log in to the Wyebot cloud dashboard.