Page 11 of 31 Pages
2.2.2. Description of the panel
Main display
The actual measuring values of an active sensor/instrument are displayed. By using the
mode SENSOR the other connected sensors/instruments may be chosen for display.
Indicator of
inclination
direction
The pictograph indicates the direction of the inclination
declining to the right (negative angle)
inclining to the right (positive angle)
Selection pointer
With the selection pointer the intended function can be chosen:
SENSOR
ABSOLUTE
REL ZERO
UNIT
ZERO
LIMITS
FILTER
ADDRESS
CALIB
ONLINE
Select the active sensor/port
Absolute measuring mode
Relative measuring mode
Selection of measuring units
Set absolute zero
Output of control signals
Adjustment of filter type (ZEROTRONIC
only)
Display and changing of sensor addresses
Calibration of sensors
Display of active communication through
port
Battery display
"BATT"
When the battery power is low, the sign "BATT" is flashing
During the process of charging, the sign "BATT" is constantly on
Measuring units
The actual measuring unit is displayed. 10 basic units are
available and most of them can in addition be changed into
subunits.
Sensor/port A-B
Function - 1 -
The connection/port is displayed for
information concerning:
- the displayed measuring value
- active sensor/instrument for calibration
purposes
Function - 2 -
Shows the measuring mode e.g. individual
measuring or differential measuring (A-B)
Sensor address
The active sensor address is displayed
To Next Page
Loading...
