Wylie i3000 - User Manual

Page 1
55M3000AQE
i3000 Quick Reference
ALARMS
SLEW ANGLE
BOOM LENGTH
HOIST
STATE DISPLAY
BOOM ANGLE
RADIUS
LOAD
UNITS
LOAD CAPACITY
BARGRAPH
DUTY NUMBER
HEIGHT
PARTS (FALLS)
i3000 TELESCOPIC CRANE INTERFACE DESCRIPTION
DISPLAY BUTTONS PRESENTATION
Shows system’s modes.
Shows hoists for selection. Also
used to scroll up in menus or
increase modifiable values.
Shows parts of line (falls). Also
used to scroll down in menus or
decrease modifiable values.
Select button. Used to select a
highlighted item in a menu.
Escape from a menu list. Also
used to cancel modification of a
value.
Switch the load display between
the actual load and the tare
load.
Bypass the motion cut (lockout).
Enter the rigging mode.
Shows all the information
regarding the actual crane
configuration.
Shows the menu for the selection
of duty by number or by crane
configuration.
Shows the problem source when
a fault is detected.
+
Press button #1 and button #4 simultaneously to reset
the system. This could be usefull if the system stalls or
becomes unstable due to DC power supply regulation.
Overload
condition
Rope
limitation
Approach warning
of overload
ATB
active
Cut-off
condition
Preset limit(s)
reached

Summary

i3000 Telescopic Crane Interface Description

Alarms Overview

Presents the different alarm conditions including approach warning, overload, and cut-off.

Display Button Functions

Details the function of each display button and its role in system operation.

i3000 Basic Operation

Hoist Selection

Guide to selecting the desired hoist for crane operations.

Parts of Line Selection

Instructions for selecting the correct parts of line configuration.

Changing Duty Number Configuration

Steps to modify the crane's duty number for configuration.

Changing Parameter Configuration

Procedure for altering crane configuration using parameter selection.

Bypassing Lock-Out Condition

Method to bypass the crane's lock-out condition.

Rigging Mode

Procedure for entering and operating in rigging mode.

Crane Configuration Information

How to display actual crane configuration and system version.

Fail Information Display

How to view detected fails when prompted by the system.

System Configuration

Language Selection

Instructions for changing the display language of the W3000 system.

Units Selection

Guide to selecting preferred unit combinations for display.

System Configuration and Diagnostic Menu

Reverse Video Display

How to invert display colors for better visibility in various lighting.

Fails Enabled or Disabled

Procedure to enable or disable system fail warnings.

Diagnostic Menu Access

Steps to access the diagnostic menu for sensor signal verification.

i3000 Range Limiting Device (Optional)

Accessing Range Limiting Mode

Steps to enter the range limiting mode on the crane interface.

Limit High Programming

Instructions for programming the maximum boom tip height limit.

Free Zone Programming

Procedure to program a free zone limit using two wall positions.

i3000 Range Limiting Device (Optional) - Part 2

Variable Limit Height Programming

How to program a variable limit for boom tip height.

Variable Limit Radius Programming

Procedure to program a variable limit for boom tip radius.

Deleting a Programmed Limit

Steps to remove a previously programmed range limit.

Wylie i3000 Specifications

General

Brand	Wylie
Model	i3000
Category	Construction Equipment
Language	English