Need help?Do you have a question about the Wynn's Aircomatic III and is the answer not in the manual?
Fill machine, position unit, connect power, and set internal temperature.
Configure fan speed, airflow, ventilation mode, and start engine.
Connect outlet tube, start engine, and initiate the cleaning process.
Exit vehicle, ventilate, disconnect unit, and perform rinsing.
Fill machine with Air Purifier, position unit, connect power, set ozone level.
Alternative locations for placing the machine inside the vehicle.
Procedure for removing remaining liquid from the machine.
Routine cleaning and refilling steps after each use.
Instructions for replacing the device's filter.
To Next Page
General