To Next PageTo Next Page
Need help?Do you have a question about the X-10 POWERHOUSE PS561 and is the answer not in the manual?
General| Model | PS561 |
|---|---|
| Compatibility | X-10 |
| Power Source | AC |
| Communication | Powerline |
| Type | Security System |
Equipment generates radio frequency energy and may cause interference if not used properly.
Security Console is FCC registered. Instructions for compliance prior to installation and use.
Select a central location for the Console, near a phone jack, and visible.
Steps for plugging in, extending antenna, connecting phone, installing battery, and setting codes.
Procedure to initialize the HT544 Remote Control with the Console.
Procedure to initialize the KF574 Keychain Remote Control with the Console.
Procedure to initialize the SH624 Remote Control with the Console.
Steps for physically mounting Door/Window Sensors and their components.
Instructions for connecting multiple door/window sensors in series.
Explains switch settings for sensitivity and compatibility with remote controls.
Steps to test the motion detector's functionality and alarm tripping.
Guidelines for optimal positioning of motion detectors for best coverage.
How to connect and configure Lamp Modules for alarm flashing and control.
How to install and configure Wall Switch Modules for alarm flashing and control.
Procedure to set Housecode and Unit Code for the POWERHORN siren.
Methods to trigger the POWERHORN siren using other X-10 controllers.
Instructions for programming emergency contact phone numbers into the Console.
Steps to record and store a 15-second voice message for the dialer.
Explains the meaning of different indicator states for zones.
Details on how to arm and disarm the system and what happens during an alarm.
How to set up and use the instant alarm mode with remote controls.
How to set up and use the delayed arm/alarm mode.
Using SH624 to arm system with or without motion detectors.
Procedure for replacing batteries in HT544, KF574, and SH624 remote controls.
Procedure for replacing batteries in Door/Window Sensors and re-registering them.
Procedure for replacing batteries in Motion Detectors and re-registering them.
Procedure for replacing the Console's backup battery.
Checks to perform if the security system fails to arm.
Diagnosing slow flashing, rapid flashing, or incorrect zone indicators.
Steps for dealing with repetitive trouble alarms and bypassing faulty zones.
Solution to prevent false alarms upon entering the house.
Troubleshooting steps for remote light control failures.
Checks to perform if the alarm fails to activate when a zone is breached.
Troubleshooting for misaligned sensors or connection issues.
Explanation of why appliances might turn off during an alarm event.
Actions for Console battery indicator and zoning behavior problems.
Resolving neighbor interference, lost remotes, and unintended system changes.
Steps to resolve continuously lit red lights during remote or sensor installation.
Troubleshooting POWERHORN activation and false motion detector alarms.
Checks for Console failing to dial out or play back messages.
Troubleshooting Console lock-ups and SP554A ARM HOME compatibility.
