• N-COM - NOLAN COMMUNICATION SYSTEM PRE-SETTING
(Available depending on the product version).
Your X-Lite helmet is factory-present to be equipped with the N-Com communication system. During the
communication system installation (see the specific instructions contained in the N-Com kit), it will be necessary to
remove the foam material fillers located in the polystyrene cheek pads next to the N-Com earphones seats.
WARNING
- The above-mentioned fillers should only be removed if the helmet is used with an N-COM compatible system
installed.
• N-COM - NOLAN COMMUNICATION SYSTEM PRE-SETTING
(Available depending on the product version).
Your X-Lite helmet is factory-present to be equipped with the N-Com communication system. During the
communication system installation (see the specific instructions contained in the N-Com kit), it will be necessary to
remove the foam material fillers located in the polystyrene cheek pads next to the N-Com earphones seats.
WARNING
- The above-mentioned fillers should only be removed if the helmet is used with an N-COM compatible system
installed.
To Next Page
