LEVER P/J
The helmet can be used with the chin guard and the visor open only during a stopover and when the vehicle is
stationary.
In these cases, it is recommended to place the side chin guard locking lever in position “J”.
Fig. 4B (slider downwards)
When the side locking slider is in position “P” (Fig.4B, lever downwards), the chin guard can be opened and/or
closed.
Fig. 4A (slider upwards)
When the side locking slider is in position “J” (Fig.4A, lever upwards), the chin guard cannot be closed, remaining
locked in open position.
WARNING
In this configuration, the chin guard cannot be closed again. Do not force the closing of the chin guard
because it could cause damages in the helmet’s closing mechanism. To close the chin guard, it is
necessary to move the locking slider to position P (Fig.4B, lever downwards).
• VISOR
3. Visor Disassembly
3.1. Close the chin guard (if open) and open the visor completely.
3.2. Press and hold the visor release button (A) down and slide the visor forwards until it clicks. (Fig.5).
3.3. Free the visor fastenings (B1 and B2) from their seats. (Fig.6).
3.4. Repeat the same steps on the other side of the helmet.
4. Visor Assembly
4.1. Close the chin guard (if open) and set the visor in open position by placing the visor fastenings (B1 and B2) in
line with the housings in the visor mechanism (Fig.6).
4.2. Insert fastening B1 in the provided housing and press the visor against the shell in line with fastening B2.
This will push the visor release button (A).
4.3. Slide the visor backwards until the visor release button (A) clicks.
4.4. Repeat the same steps on the other side of the helmet.
4.5. Close the visor completely.
LEVER P/J
The helmet can be used with the chin guard and the visor open only during a stopover and when the vehicle is
stationary.
In these cases, it is recommended to place the side chin guard locking lever in position “J”.
Fig. 4B (slider downwards)
When the side locking slider is in position “P” (Fig.4B, lever downwards), the chin guard can be opened and/or
closed.
Fig. 4A (slider upwards)
When the side locking slider is in position “J” (Fig.4A, lever upwards), the chin guard cannot be closed, remaining
locked in open position.
WARNING
In this configuration, the chin guard cannot be closed again. Do not force the closing of the chin guard
because it could cause damages in the helmet’s closing mechanism. To close the chin guard, it is
necessary to move the locking slider to position P (Fig.4B, lever downwards).
• VISOR
3. Visor Disassembly
3.1. Close the chin guard (if open) and open the visor completely.
3.2. Press and hold the visor release button (A) down and slide the visor forwards until it clicks. (Fig.5).
3.3. Free the visor fastenings (B1 and B2) from their seats. (Fig.6).
3.4. Repeat the same steps on the other side of the helmet.
4. Visor Assembly
4.1. Close the chin guard (if open) and set the visor in open position by placing the visor fastenings (B1 and B2) in
line with the housings in the visor mechanism (Fig.6).
4.2. Insert fastening B1 in the provided housing and press the visor against the shell in line with fastening B2.
This will push the visor release button (A).
4.3. Slide the visor backwards until the visor release button (A) clicks.
4.4. Repeat the same steps on the other side of the helmet.
4.5. Close the visor completely.
To Next Page
Loading...
