4. Setting up the front tyre (Picture 5,6,7,8)
Need tools: 12-14 wrench,13-17 wrench, M8 hexagram
First loosen the nut on the front tyre, and connect to the frame with right
direction, then tighten the nut. (Picture 5,6)
Picture 5 Picture 6
Second, there is a nut and a spacer bush on the steering tie rod , only loosen
the nut, then connect it to the frame and tighten it. (the spacer bush will be
fixed above the plate , the nut will be under the plate ) (Picture 7,8)
Picture 7 Picture 8
To Next Page
Loading...