X Rocker XR Racing V2 - Program Pedals and Wings as Y Axis; Wheel Sensitivity Adjustment

-6-
Program Pedals as Y axis
1. Press and hold SHARE +OPTIONS 3 seconds until the green
LED turns on.
2. Press LEFT of the D-PAD. The green LED will turn off. Pedals
are programmed as Y function.
Program L-Wing and R-Wing as Y axis
1. Press and hold SHARE for 3 seconds until the green LED turns
on.
2. Press RIGHT of the D-PAD. The green LED will turn off. Pedals
are programmed as Y function.
3 levels wheel sensitivity adjustment
1. Press and hold SHARE + OPTIONS for 3 seconds until green
LED is on. Release the button.
2. Press SHARE again. Current sensitivity is displayed via the LED
on the wheel
3. Press SHARE a third time to select sensitivity level. It cycles as
below:
Middle (Green LED is flashing) High (Green LED flashes quickly) Low (Green LED flashes slowly)
- Press UP of the D-PAD to confirm and leave the settings mode
ENG