x-sense WS01 User Manual

Testing the Device
After the device is activated, you must test the device to ensure it is
operating normally. Press the Test button at the bottom of the device.
The alarm will deliver 3 beeps paired with the red LED flashing. The
sound will automatically stop after the test is completed.
Water Leak Detection
This water leak sensor is used to detect water leaks and floods. Once a
water leak occurs, the device will sound an alarm continuously paired
with a flashing red LED. If the user takes no action at this time, the
device will continue to sound an alarm until the battery runs out.
Silencing the Device
When the device is triggered, press the Silence button to mute the
alarm, which will last for 10 seconds. After 10 seconds, the device will
continue to sound an alarm. To disable the alarm, you must completely
clean and dry the surface of the device.
05

x-sense WS01 Specifications

General

Brand	x-sense
Model	WS01
Category	Accessories
Language	English