X-Taste X3 - Page 4

4
 Power control / Temperature control mode
 Battery Management
o Support maximum up to 1.0A USB charging current.
o Approximate 3 hour for 2600mAH LI-On battery.
 Safety feature
o Dry coil protection (only applicable for temperature control mode)
o
Coil overheat protection
 Support Ni200, Ti01/02, SS316L, NiFe30, NiFe70, Nichrome N60. Refer to coil
material table for detail.
 Protection temperature can be change through “X-Taste Advance”.
o Real-time on-board temperature monitoring. Auto shutdown device if temperature
too high.
o
Real-time battery temperature monitoring. Auto shutdown device if battery
temperature too high.
o Battery health condition checking feature. Able to give alert if battery not in good
condition.
o
Coil over voltage protection.
o Coil over current protection.
o
Coil short/open circuit protection.
o Weak battery protection.
o Battery over charge protection.
o Battery over load protection.
o 10 seconds maximum fire duration protection.
o
Battery reverses polarity protection.
 Support firmware upgrading through USB port.
 Screen lock features.
 Coil resistance measurement features.
 Real-time display data during fire on
o Battery voltage, capacity
o Coil resistance (power mode)
o Sensing coil temperature (temperature mode)
o
Coil voltage
 Auto power off features
o
Can be modifying through “X-Taste Advance”.
 5 individual preset configurations.
 Auto/left/right screen rotation.
 Continuous short press “Fire ON” button 3 times to power on devices.
 Smart auto lock coil resistance. No need to manual lock resistance for temperature control.
 Using TCR or temperature coefficient based on type of coil material for more precise
temperature control and coil overheats protection.
 X-Taste Advance software allow user to modify setting and operation of the device.