To Next Page

To Previous Page



Page 2

Step 1: Hardware Installation

You need to set up your camera using a network cable (wired) first before you attempt to use it wirelessly. It is

recommended that you set the camera up indoors first, before routing the cables through an external wall to mount it

outdoors.

1. Install the Wi-Fi antenna.

2. Plug the power adaptor into the camera and into an AC outlet.

3. Plug one end of the network cable into the camera, and the other end into your router/switch.

Step 2: Software Installation

Install the following software:

1. IP Camera Tool: Open the CD, click “IPCamSetup.exe”—“Next”—“Next”—“Close”.

2. ActiveX: Click “Appinstall.exe”—“Next”—“Install”—“Finish”.

After this is done, the icon “IP Camera Tool”

will be displayed on your desktop.

Questions and Answers:

Need help?

Do you have a question about the X10 AIRSIGHT XX36A and is the answer not in the manual?

X10 AIRSIGHT XX36A Specifications

General