9
digits represented by 01B are the REN without a decimal point (e.g., 03 is a REN of 0.3). For earlier
products, the REN is separately shown on the label. If your equipment causes harm to the telephone
network, the telephone company may discontinue your service temporarily. If possible, they will
notify you in advance. But if advance notice is not practical, you will be notified as soon as possible.
You will be informed of your right to file a complaint with the FCC. Your telephone company may
make changes in its facilities, equipment, operations or procedures that could affect the proper
functioning of your equipment. If they do, you will be notified in advance to give you an
opportunity to maintain uninterrupted telephone service. If you experience trouble with this
telephone equipment, please contact the following address and phone number for information on
obtaining service or repairs. The telephone company may ask that you disconnect this equipment
from the network until the problem has been corrected or until you are sure that the equipment is
not malfunctioning. This equipment may not be used on coin service provided by the telephone
company. Connection to party lines is subject to state tariffs.
COMPANY: Zakus, INC.
ADDRESS: 146 Main Street, suite 208 Los Altos, CA 94022 U.S.A.
TEL NO: 650-917-9158
A plug and jack used to connect this equipment to the premises wiring and telephone network must
comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant
telephone cord and modular plug is provided with this product. It is designed to be connected to a
compatible modular jack that is also compliant. See installation instructions for details.
Warning: If the device, xCE-200WU-UH, is used without the detachable privacy shield, the
following criteria needs to be met by the Installed Environment of the device for complying with
the PCI privacy screen design requirement:
A. Positioning of the device on the check-stand in such way as to make visual observation of
the PIN-entry process infeasible.
Visual shields designed into the check-stand.
Position the device so that it is angled in such a way to make PIN
spying difficult.
B. Pop-up (temporary) privacy shield attached to the device mounting stand. Consumer
(through education & prompting) or merchant would put the shield in place during PIN
entry.
C. Installing device on an adjustable stand that allows consumers to swivel the terminal
sideways and/or tilt it forwards/backwards to a position that makes visual observation of
the PIN-entry process difficult.
D. Positioning of in-store security cameras such that the PIN-entry keypad is not visible.
E. Instructing the cardholder regarding safe PIN-entry, done with a combination of:
Signage on the device.
Prompts on the display, possibly with a "click-through" screen.
Potentially literature at the point of sale.
A logo for safe PIN-entry process.
To Next Page
Loading...
Need help?
General