08905155A - 6 -
Connector Function
1 Gain Adjustment DIP Switches
Adjust Input GAIN from analog sources to
avoid distortion.
2 Output RJ-45 Connector
Connects to D5KP Keypad\Amplifier, D5R44H
(D5RE6H) or D5M44H (D5M14H) Digital Audio
Distribution Hubs.
Installation
The D5IP is designed to mount in a standard single-gang rough-in box (J Box). Mount the unit in
close proximity to the location of the source that will be connected to it.
Note: Do not mount the D5IP in the same rough-in box as the high voltage devices such as electrical
outlets or switches.
After running CAT-5 and terminating the ends, route the wire into the back of the rough-in box,
connect it to the RJ-45 connector on the rear of the D5KP, and mount using the 2 provided screws.
To Next Page
Loading...