Xantech Dinky Link DL95 User Manual

INSTALLATION INSTRUCTIONS
DL95
Dinky Link™ Surface Mount
Extended Range
Plasma\LCD\LED\CFL Friendly
IR Receiver
1
DESCRIPTION
These small IR receivers have been designed for mounting in very small
spaces. They may be mounted under shelf edges, cabinet ledges, in wall
speakers, etc. – anywhere an inconspicuous appearance is desired. The high
sensitivity of these receivers allows placement behind speaker grilles and still
receive IR commands up to 120 feet away*.
FEATURES
• Wire channel for clean installation.
• System testing red-talk-back LED.
• Includes 3-Terminal Block for easy extension to remote room locations.
SPECIFICATIONS
• Infrared carrier frequency bandwidth: 25 - 60 kHz.
• Reception range: Up to 120 feet.*
• Reception angle: +/- 60 degrees.
• Cable requirements: See “INSTALLATION” below.
• Max. Transmission length: 1 mile using 18 gauge wire.
• Maximum current output: 100mA.
• Drives IR emitters through Xantech Connecting Blocks, Controllers, etc.
• Dimensions: 2.55” x 0.55” x 0.35” (65mm x 14mm x 9mm).
• Power requirements: +12VDC, 10mA.
* Depending on remote control output strength and ambient conditions.
MOUNTING
The IR receiver can be mounted to any flat surface, using the two-sided
adhesive tape supplied. Two screws are included for mounting the 3-terminal
block provided with the IR receiver.
An additional feature is a wire channel on the rear of the surface mount IR
receiver. This will give the installer the ability to provide clean wire dressing in
any direction.

Xantech Dinky Link DL95 Specifications

General

Brand	Xantech
Model	Dinky Link DL95
Category	Receiver
Language	English

Summary

Product Description and Features

Description

Details the small IR receivers designed for discreet mounting in various spaces.

Features

Highlights key features like wire channel, talk-back LED, and 3-terminal block.

Specifications

Lists technical details including frequency, range, angle, and power requirements.

Mounting Instructions

Provides guidance on mounting the IR receiver using adhesive tape or screws.

Installation Guide

IR Receiver Cable Wiring

Illustrates the wiring connections for the DL Series IR Receiver.

Local System Application

Explains placement for controlling AV equipment in a central location.

Remote Room Application

Details extending control to AV equipment from a remote room location.

Troubleshooting

Interference Issues

Addresses common IR/RF interference sources and identification methods.

Talk-Back LED Behavior

Explains correct and incorrect blinking patterns of the talk-back LED.

Connection Checks

Guides on verifying power supply and plug connections.

Emitter Placement

Recommends repositioning emitters if components do not respond.

Limited Warranty Information