3
Warning –Button cells
• Do not ingest battery,risk of burns due to
dangerous substances.
• This product contains button cells. If swallowed,
the button cell can cause severeinternal burns
within just two hours and lead to death.
• Keep new and used batteries out of the reach
of children.
• If the battery compartment does not close
securely,stop using the product and keep it out
of the reach of children.
• If you think that batteries wereswallowed or are
in apart of the body,seek medical assistance
immediately.
4. Controls and Displays
• ON/TARE button: The device switches on after this
button has been quickly pressed once. Press and
hold the button to shut the device off.This button
is also used to control the tarefunction.
• UNIT button: Setting the unit of measurement:
Grams (g), ounces (oz), millilitres (ml) or pounds (lb)
Note
• The millilitredisplay is based on the specic
weight of water or milk.
5. Getting Started
5.1 Insert the batteries:
• Use aPCS CR2032 coin cell battery.
• To change the battery,open the battery cover
on the back of the device, insert aCR2032
battery with the correct polarity into the battery
compartment.
• Close the battery compartment fully
6. Operation
• Place the scales on aclean, level table.
• Make surethat the scales arestable and do not
tilt.
Weighing:
• Switch the scales on using the ON/TARE button.
“0 g” appears on the display after afew seconds.
• Once “0 g” is displayed, lay the object to be
weighed on the scales. The weight is then shown
on the display.
• After the object has been placed on the scales,
you can set the scales to zero(tare) using the
ON/TARE button. This allows you to subtract the
weight of acontainer,for example, if you want to
weigh ingredients. Once you have weighed one
ingredient, additional ingredients can be weighed
by setting the scale again to zero.
• As soon as you are nished weighing, remove the
container from the scales. The display will now
show how heavy the object was beforethe last
tarewith anegative sign (the minus sign appears
on the left).
• Once the display remains stable, the scales will
automatically switch off after 60 seconds. You
can also switch off the scales manually by holding
down the ON/TARE button.
Error messages
• When the error message “EEEE” is shown, the
scale is overloaded.
• When the error message “LO” is shown, the
battery is empty.Replace the empty battery as
soon as possible.
Note
• When the weight displayed by the scales seems
to be incorrect, check that the contact between
battery and the contacts is in proper working
order.Ifyou haven’t used the scales in along
time, change the battery and try again