Xblitz GENESIS 4K - Menu Functions

10
3. The camera must be turned o when inserng the memory card,
otherwise the card and the device may be damaged. The same
applies to removing the card from the device.
4. When the memory card becomes full, the oldest unprotected
recordings will be overwrien.
5. It is recommended that you set the G – SENSOR opon to minimum
to avoid protecng unnecessary footage and thus losing memory
card space. The card should be formaed in FAT32 le system rst
on your computer, then on the recorder.
6. Audio: The device is equipped with a condenser microphone that
records all ambient sounds. The sounds may overlap, causing
distoron.
04. INSTALLATION
SEE FIGURE B
1. Select and clean a mounng locaon for the camera.
2. Mount the camera bracket.
3. Insert the memory card into the camera.
4. Place the camera in the camera mount.
5. Point the camera lens towards the roadway.
6. Connect the power adapter to the camera.
7. Route the power cable so that it does not obstruct your view while
driving (see picture B).
8. Plug the power adapter into the cigaree lighter socket of the car.
05. MENU FUNCTIONS
1. Recording Resoluon: 4K—30 FPS / 2K – 30 FPS 2.
2. Video encoding: h.265 / h.264
3. Speed units: km/h or mph
4. Screen standby: o / 1 min / 3 min
5. Frequency: 50HZ / 60HZ
6. G-Sensor Sensivity: O / Low / Medium / High
7. Parking Mode: O / Low / Medium / High
8. Moon detecon
9. Date Format: Select date format
10. Audio: Audio recording: On / O
11. Volume: adjust the volume of the system sounds
12. Loop Recording: me of individual recordings: 1min / 3min / 5min
13. Time seng
14. Time zone seng
15. Language: Polish, Italian, Czech, Hungarian, German, Spanish,
French, English