23
10. FAQ
1. The device does not turn on.
It is recommended to check the power source.
2. The device does not turn on/o automatically.
The reason for this behavior may be the constant power supply in the car lighter
socket.
3. The device restarts while driving.
It is recommended to check the power source.
4. The device does not record in a loop (records randomly).
Check the setting of the "motion detection" function and "parking mode" – both
should be disabled when driving.
5. The application shows the message "Memory full".
Check the "G-sensor" and "parking mode" functions and set them to a minimum.
The card must be formatted in FAT32 format first on the computer and then in the
recorder.
6. The device records noise or distorted, blurred sound.
The device has a very sensitive microphone that records any sounds from the
environment. Recorded sounds can overlap. The windshield air supply can also
distort the sound.
7. The device does not respond.
Briefly press the RESET button or restore the device to factory settings.
Due to the continuous improvement of the products, the manufacturer reserves
the right to change the device and its kit without prior notice, some of the features
described in this manual may slightly dier from reality.
WARNING! Use only the original 5V/1.5A charger.
(Do not connect directly to the 220/230V socket). Failure to follow
the recommendations may cause damage to the camera
or dangerous situations.
WARNING! Playing files on a computer:
The camera does not have a mass memory drive mode. To play the
files on a computer, take the memory card out of the device and use
a memory card reader to connect it to a computer.
EN
To Next Page
Loading...