- 13 -
FAQ:
1) The device does not turn on, the display is blinking.
✓ It is necessary to charge the device’s battery before the first use.
2) The device does not turn on,/turns off automatically.
✓ The reason for this may be constant powering by the cigarette lighter socket.
3) The device reboots while driving.
✓ Check the power source.
4) Loop recording does not work (the device records randomly).
✓ Check the functions "Motion Detection" and "Park Mode". They both should be turned off while driving.
5) The device displays the message "memory card full"
✓ Check the "G-sensor" and "Park Mode" sensitivity settings – both should be set at a minimum.
✓ The memory card must be formatted in FAT32 format first on the PC and then on the recorder.
6) The device records the noise and distorted, indistinct sound:
✓ The device has a very sensitive microphone, which records all the sounds from the environment. The sounds may overlap. Airflow
windscreen effectively distorts the sound too.
WARNING: Use only chargers with charging current up to 1A. (Do not connect directly to the 220 / 230V power outlet.)
Failure to follow these instructions could result in damage to the camera or, in extreme cases, to ignition.
To Next Page
Loading...
