Xblitz Z4 - Getting Started

37
EN
1. Select the camera mount location. It is best to set the camera so that
the display screen shows the largest possible area in front of the car.
Make sure that the camera does not obscure the driver's view while driving.
2. Install the holder on the windshield, then install the camera in it.
3. Move the USB cable as shown above.
4. Connect the mini USB plug to the device.
5. Connect the charger to the 12V or 24V lighter socket.
06. GETTING STARTED
1. Mount and connect the camera to the power supply.
2. Insert the micro SD memory card (formatted to FAT32 file system).
NOTE: Please insert and remove the memory card only when the device
is turned o.
3. Set the following in the menu:
a. date and time.
b. Loop recording (adjust recording time). If you turn o loop recording, files
won't be overwritten.
c. Set the highest available resolution.
d. Set the G-Sensor to the lowest possible sensitivity so that the camera
does not secure videos recorded when driving on bumpy roads.