49
5. The device shows the message "memory card full".
Check the "G-sensor" and "parking mode" functions and set them
to a minimum. The card must be formatted in FAT32 format first
on a computer and then in the recorder.
6. The device records noise and distorted, blurred sound.
The device has a very sensitive microphone that records any sounds from
the environment. Recorded sounds can overlap. The windshield's air
supply can also distort the sound recorded.
7. The device does not respond.
Briefly press the RESET button or restore the device to factory settings.
8. Horizontal strips appear on the recording.
Incorrect setting of image refresh rate values. Set the frequency value
to "50Hz" or "60Hz", depending on local settings.
EN
Due to the continuous improvement of the products, the manufacturer
reserves the right to change the device and its set without prior notice,
some of the features described in this manual may dier slightly in reality.
To Next Page
Loading...
