User Manual XC Tracer Maxx Rev 01 23.2.2020
tone=-3.00,280,100,100 means that with a sink rate of -3.0m/s a tone of 280Hz will be emitted.
As soon as the sink rate changes the tone frequency also changes, depending on the configuration.
This creates a nice sink tone (not that a sink tone is ever nice!)
You can create your own tone settings using the tone simulator on www.xctracer.com and then
copy and paste them to the configuration file, or you can simply copy and paste other people's tone
settings to the configuration file.
# FLARM device information
FlarmRadioID=200006
The Radio ID is transmitted with the Flarm signal. Have a look at www.glidertracker.de, here it is
possible to track your flight in real time. You can register your RadioID at ddb.glidernet.org and add
additional information. The Radio ID will also be used by the apps when it comes to knowing where
where your buddies are flying.
FlarmSerialNumber=FLATMXCTW-000006
This is the serial number of Flarm; this serial number is required when buying an obstacle database
firmwareVersion=6.67
Info über die installierte Flarm Firmware
firmwareExpirationDate=1.11.2020
Info until when the Flarm firmware is valid. After this date Flarm will not work anymore, a new Flarm
firmware should be installed before!
obstacleDatabase=ALPS20190121
Indicates if and which obstacle database is installed.
obstacleDataBaseExpirationDate=2019-03-31
This info indicates whether the obstacle database is still valid. The obstacle database will no longer
work after the expiration date.
# FLARM glider type is HANGGLIDER or PARAGLIDER
type=PARAGLIDER
Here you can enter either HANGGLIDER or PARAGLIDER.
# Add Radio ID and buddy name
Buddy1Name=
Buddy1RadioID=
Here you can add a name for your buddy and his or her radio ID. Or you can go to settings in the
vario and add a buddy with a few clicks on the red button, and then later on you can change here in
the config file the name of the buddy as you wish.
To Next Page
Loading...