BNC- Standard configuration provides two HDSDI loop throughs from top stage. Up to three available.
Rear Battery Housing
The rear battery housing can be moved in and out by loosening the two 10-32 SHCS. There are safety
stops on the ends so the housing will not slide off the rails. Over 4” of travel increases your panning
inertia.
Trim Knobs
The LEH comes set up with trim knobs on one side. They can be transferred to the other side of the sled
by loosening the set screw and spinning off the knobs. The left-right drive shaft must be removed and
reassembled on the opposite side. See “Swapping the inching knobs”.
Programmable Digital Level Placement
There are two 4-40 drilled and tapped holes on each side of the LEH. These holes are aligned with the
XCS HDPDL housing. The screws should not protrude into the LEH housing any more than .125”.
On Screen (LCD) Text Messages
On power up, the sled’s serial number #0000xxx and the software revision level are displayed for 4
seconds.
Listed below are on screen error messages displayed on the LCD when a failure of a cable, dead short,
accessory or camera occurs.
BATT 1 CANNOT BE 24 VOLTS- 24 volt battery connected to wrong battery plate, B3 only.
BATT 2 CANNOT BE 24 VOLTS- 24 volt battery connected to wrong battery plate, B3 only.
Above two messages are each shown for a few seconds followed by a shutdown of the sled.
24V Over Current Cycle Power- Over current draw on the system or dead short or more than 34 volt
input. Turn off power, remove the failed component, remove the batteries for 10 seconds, reinstall
batteries and turn back on.
12V Over Current Cycle Power- Over current draw on the system or dead short or more than 17.9 volt
input. Turn off power, remove the failed component, remove the batteries for 10 seconds, reinstall
batteries and turn back on.
To Next Page
Loading...