CONNECTING THE SCUBA TANK
Attention:
PROJECT buoyancy compensator is designed to be used
with tanks of parameters indicated in technical specica-
tion included at the end of this manual. Using this com-
pensator with other types of tanks, although physically
possible, is not recommended.
In order to connect the double scuba tank in proper and
safe way, read and understand the user manual delivered
with the double set.
To install the BC on double tank set:
1. Put the double tank set in the stable surface to have
bolts on the top.
2. Place the BC on the bolts. The inator’s elbow adapter
should be on the cylinder-side.
3. Place the backplate on the bolts.
4. Tighten the screws.
DANGER
AN INCORRECTLY CONNECTED TANK MAY UNEXPECTEDLY DETACH FROM THE HARNESS. SUCH SITUATION
IS EXTREMELY DANGEROUS AND MAY RESULT IN A SERIOUS ACCIDENT OR EVEN DEATH. THEREFORE THE
TANK CONNECTION HAS TO BE INSPECTED CLOSELY.
WARNING
BEFORE CONNECTING THE BCD TO THE CYLIN-
DERS CHECK THE DISTANCE BETWEEN BOLTS IF
IT’S EXACTLY 11 INCHES (279.4) AND CORRECT IF
NECESSARY.
WARNING
CHANGING THE POSITION OF THE BCD AGAINST
CYLINDERS MAY SIGNIFICANTLY AFFECT YOUR
TRIM. AFTER CHANGING THE POSITION OF THE
BCD YOU MUST CHECK THE TRIM IN SHALLOW
WATER BEFORE THE FIRST DIVE.
24
07
CONNECTING THE LP HOSE
To Next Page
Loading...
Need help?
General
