20 Achieving ideal trim
Thanks to the adjustment possibilities of the STEALTH 2.0 System, you can achieve ideal trim by moving the
center of gravity in a manner similar to the way a double-tank diver does with a V-weight, allowing for a
balanced profile regardless of whether you dive a wetsuit or dry-suit.
If trimmed properly, STEALTH 2.0 allows you to enjoy the ideal position, regardless of the gas volume in the
cylinders, and without the need to manage trim with the use of a dry-suit.
Consider these two issues before you start trimming:
I. Ideal trim is reached by locating the weight in such a position that ideal trim is achieved with near
empty cylinders;
II. The compensator shouldn’t be used for trimming, but only to compensate for shifting gas weight in
the cylinders. The compensator should be mounted around the body’s center of gravity.
The trimming procedure is as follows:
You should have 50bar of gas in each cylinder and the compensator should remain empty. Put the harness on
with a weighting system and the compensator; next walk into shallow water and balance yourself properly.
Check the trim. If it turns you head down, it means that the center of gravity is too high. The central weighting
pocket needs to be lowered or the trim pockets need to be mounted closer to your legs. In case it pulls you up
(legs down), it means that the center of gravity is too low. Move the central weighting pocket up. If it is already
in the maximum top position, move the trim pockets towards your head. In extreme cases the trim pockets
may need to be mounted on the arm straps above the upper harness band.
Note: If you use a dry-suit, the air trapped inside significantly influences trim. During the trimming process you
should not have too much air in your suit and it should be balanced neutrally, as much as possible.
To Next Page
Loading...
Need help?
General
