Xenith BACK PLATE User Manual

HARDWARE CONTENTS
STEP 2
STEP 4
STEP 1
STEP 3
STEP 5
Feed lower end of attachment strap with
two grommets through slot in back plate
from outside to inside. Select inner or outer
slot to best match up with slots in
shoulder pad.
2 Attachment Straps
2 Elastic Hardware Covers
4 T-Nuts
4 Screws
Place elastic hardware cover onto attach-
ment strap.
Feed upper end of attachment strap
through slot in shoulder pad from outside
to inside.
Feed upper end of attachment strap back
through elastic hardware cover
Align the two grommet holes on the lower
end of the attachment strap with one of
the grommet holes from the upper end, and
place a t-nut through the three grommet
holes from back to front. The vertical
position of the pad can be adjusted using
the dierent grommet holes.
STEP 6 STEP 7
Install screw through front of grommet holes
into t-nut and tighten.
Slide elastic hardware cover over t-nut and
screw. Repeat process from step 1 for
other attachment strap location.
ASSEMBLY INSTRUCTIONS: XENITH SHOULDER PADS
BACK PLATE
BACK PLATE
FRONT

Xenith BACK PLATE Specifications

General

Brand	Xenith
Model	BACK PLATE
Category	Accessories
Language	English

Summary

Back Plate Assembly Instructions: Xenith Shoulder Pads

Step 1: Strap Insertion

Feed lower end of attachment strap through slot in back plate from outside to inside.

Step 2: Hardware Cover Placement

Place elastic hardware cover onto attachment strap.

Step 3: Shoulder Pad Strap Feed

Feed upper end of attachment strap through slot in shoulder pad from outside to inside.

Step 4: Re-feed Strap Through Cover

Feed upper end of attachment strap back through elastic hardware cover.

Step 5: Align Grommet Holes

Align the two grommet holes on the lower end of the attachment strap with one of the grommet holes from the upper end.

Step 6: Secure with Screw and T-Nut

Install screw through front of grommet holes into t-nut and tighten.

Step 7: Final Cover and Repetition

Slide elastic hardware cover over t-nut and screw. Repeat process for other strap.

Back Plate Assembly Instructions: Non-Xenith Shoulder Pads

Step 1: Strap Insertion

Feed lower end of attachment strap through slot in back plate from outside to inside.

Step 2: Hardware Cover Placement

Place elastic hardware cover onto attachment strap.

Step 3: T-Nut Insertion

Place a t-nut through the two lower grommet holes in the strap from back to front.

Step 4: Secure with Screw

Install screw through front of grommet holes into t-nut and tighten.

Step 5: Shoulder Pad Attachment

Feed a t-nut through the shoulder pad hole and attachment strap grommet hole.

Step 6: Final Cover and Repetition

Slide elastic hardware cover over t-nut and screw. Repeat process for other strap.