Why is my Xerall Drone lacking power or unable to fly?
If your Xerall Drone lacks power or is unable to fly, it might be due to several reasons. The propeller might be severely deformed, in which case you should replace it. Another cause could be a low battery; charge it according to the instructions. Finally, check for incorrect installation of the propeller and refer to the instructions to replace it correctly with a new one.
What to do if the remote control can’t connect to my Xerall Drone?
If the remote control can’t connect to the Xerall Drone, it could be due to several reasons. First, the indicator lights might not be working; refer to the solutions for that issue. There might be interference signals nearby, so try restarting both the aircraft and the remote control. Ensure you are operating it correctly according to the instructions. Finally, damage from repeated heavy impacts could be the cause; in that case, consider purchasing new components from the local distributor.
Why does my Xerall Drone can't hang up and stop to one side?
If your Xerall Drone can't hang up and stops to one side, several factors could be the cause. The drone might be uncalibrated; refer to the Calibration description in the guidebook. Severe propeller deformation could also be the issue; replace the paddles with new ones of the same type. Check for deformation of the motor base, and replace the motor seat components if necessary. If the gyroscope did not reset after a violent impact, level the drone on the horizontal ground for about 10 seconds or restart it, then operate it according to the explanation. Motor damage or no proofreading compass can also be the cause, so refer to the instruction to replace the right motor or re-proofread the compass.
How to fix indicator lights that don’t work on Xerall X-TANKCOPTER Drones?
If the indicator lights on your Xerall Drone don’t work, it could be due to a low battery. Replace the batteries with the same type. Another cause might be mixed battery polarity; install the batteries according to the installation instructions. Poor contact could also be the issue; clear out any dirt between the battery and the cells.
What to do if the indicator lights don’t work on Xerall X-TANKCOPTER Drones?
If the indicator lights on your Xerall Drone aren’t working, it could be due to a low battery. Charge the battery according to the instruction. Alternatively, the battery may have exceeded its usage limit or power discharge protection; purchase new batteries or charge the battery according to the procedures. Poor contact could also be the cause; unplug the power plug and insert it again correctly.
Why can't I see the image from my Xerall Drone?
If you can't see the image from your Xerall Drone, it might be due to interference signals nearby. Try pulling out the line and inserting it again. If that doesn't work, the video component might be damaged; consider purchasing a new one from the local distributor.
Details the physical components and layout of the drone, including LEDs, camera, and cover.
Lists key specifications such as drone size, weight, battery, flight time, and camera resolution.
Details the functions of various buttons and sticks on the drone's transmitter controller.
Provides instructions for inserting AA batteries into the drone transmitter.
Provides step-by-step guidance on how to install a smartphone onto the drone controller.
Explains how to charge the drone battery using various power sources.
Advises on the proper and safe disposal methods for lithium-polymer batteries.
Illustrates the correct procedure for installing and removing drone propellers.
Details the steps for replacing a damaged motor on the drone.
Shows how to load and unload the drive belt for the drone's tank-like mechanism.
Instructions for replacing front and rear scaffold brackets.
Details the process of inserting the drone's lithium battery into its compartment.
Covers essential checks for battery, stick position, connections, propeller rotation, and belt security.
Describes the process of connecting the transmitter and drone for remote control.
Explains initiating flight and automatic landing using the Take Off/Landing button.
Instructs on how to immediately stop the drone's motors in critical emergency situations.
Guides on calibrating the drone for stable flight after pairing.
Explains how to start and stop the drone's motors using the transmitter control sticks.
Describes how to switch between ground running and flight modes using the right stick.
Details drone ascent, descent, and yaw control with the left stick.
Explains drone forward/backward movement and yaw control with the right stick.
Guide to adjusting drone flight path and orientation using trimmer buttons and sticks.
Details specific stick movements for combined forward, backward, and turning actions.
Explains stick combinations for executing left and right turn circles.
Enables stable hovering by calculating position, aiding beginners and aerial photography.
Allows switching between low speed for beginners and high speed for experienced pilots.
Explains the headless mode feature for easier drone orientation control during flight.
Alerts user to low transmitter battery or drone exceeding operational limits.
Automatically stops motors when propeller is stuck, with reset instructions.
Guide to downloading and installing the Xerall mobile application for drone control.
Details TF card insertion, saving video, and transferring aerial photography data.
Identifies specific accessories like smartphone holder, transmitter, and VR goggles.
States that product design and specifications are subject to change without notice.
Provides information on FCC regulations, interference, and device compliance.
States that the device meets general RF exposure requirements for portable use.
To Next Page
General