Properties:
• Independent high and lowpass filter can be configured either as highpass, lowpass or without filter.
• 2 channels can be run in bridged mode for higher output power.
• 2ch mode Highpass: drives 2 satellite speakers
• 2ch mode Lowpass: drives 2 (or more) subwoofers
• 1ch mode Lowpass: drives 1 subwoofers in bridged mode Protection circuit: Overload, Short-circuit, DC, Overheat
Safety:
• Before you make any connection, the battery must be disconnected!
• A main fuse must be installed into the +12 V wire within the first 12" from the + terminal of the battery (insurance regulation!).
• Please note that a minimum speaker impedance of 2 Ohms must be maintained. Do not connect speakers with lower impedance in
normal as well as 4 Ohms in bridged mode!
• Make sure that you do not use defective speakers and subwoofers.They can cause damage to your amplifier!
• The fuses inside the amplifier only protects the device itself, not the battery and the car!
Important notice stability of amplifiers:
Normal operation:
Every amplifier is only capable of driving loads (speakers) up to a certain limit, which is set either by the protection circuits or the maximum
power output. XETEC amplifiers accept loads down to 2 Ohms in normal operation.
Bridged mode:
In bridged mode each two channels of the amplifier are driving the same load, the acceptable impedance for each channel is also divided by
two!
– 4 –
Vektor_V_150.2_E 13.05.2003 8:21 Uhr Seite 4
To Next Page
Loading...