Supports a variety of drive configurations. For details, see 
5.2.5.1 Drive Configurations . 
⚫ 
Supports two M.2 SSDs. 
−  M.2 SSDs are supported for RAID configuration when 
the server is configured with an Avago SAS3004iMR 
RAID controller card. 
NOTE 
⚫ 
The M.2 SSD is used only as a boot device for installing the OS. 
Small-capacity (32 GB or 64 GB) M.2 SSDs do not support 
logging due to poor endurance. If a small-capacity M.2 SSD is 
used as the boot device, a dedicated log drive or log server is 
required for logging. For example, you can dump VMware logs in 
either of the following ways: 
⚫ 
Redirect /scratch. For details, see 
https://kb.vmware.com/s/article/1033696. 
⚫ 
Configure syslog. For details, see 
https://kb.vmware.com/s/article/2003322. 
⚫ 
The M.2 SSD cannot be used to store data due to poor endurance. 
In write-intensive applications, the M.2 SSD will wear out in a 
short time. 
If you want to use SSDs or HDDs as data storage devices, use 
enterprise-level SSDs or HDDs with high DWPD. 
⚫ 
The M.2 SSD is not recommended for write-intensive service 
software due to poor endurance. 
⚫ 
Do not use M.2 SSDs for cache. 
⚫ 
Supports hot swap of SAS/SATA/NVMe U.2 drives. 
NOTE 
The NVMe drives support:   
⚫ 
Before using the VMD function, contact technical support 
engineers of the OS vendor to check whether the OS supports the 
VMD function. If yes, check whether the VMD driver needs to be 
manually installed and check the installation method. 
⚫ 
Surprise hot swap if the VMD function is enabled and the latest 
Intel VMD driver is installed. 
⚫ 
Orderly hot swap if the VMD function is disabled. 
⚫ 
Supports a variety of RAID controller cards. For details, 
see "Search Parts" in the Compatibility Checker. 
−  The RAID controller card supports RAID configuration, 
RAID level migration, and drive roaming. 
−  The RAID controller card supports a supercapacitor for 
power-off protection to ensure user data security. 
−  The PCIe RAID controller card occupies one PCIe slot. 
For details about the RAID controller card, see V6 Server 
RAID Controller Card User Guide.