Side Brush
14
1. Turn the robot vacuum over and pull out the side brush upwards.
2. Clean any hair or dirt from the side brush.
3. Reinstall the side brush.
Note:
It is recommended to clean the side brush once every two weeks to ensure the
cleaning effect. Reinstall the side brush aer cleaning.
Caster Wheel
1. Turn the robot vacuum over and pull out the caster wheel upwards.
2. Clean any hair or debris that may have got stuck in the caster wheel.
3. Reinstall the caster wheel.
Cleaning the Brush
Use a knife to cut the hair Clean dirt
Note:
When the hair is tightly tangled, do not forcibly pull on it, as this could damage the
brush.
Care & Maintenance
Dirty Water Tank
Clean the dirty water tank in time aer the mop pads are cleaned in the
mop-cleaning station.
Brush Cover
Brush
Brush
1. Flip the robot vacuum over and pinch the two release buons to remove
the brush cover.
2. Remove the brush and pull out the brush bushing.
3. Use scissors or a blade to cut hair tangled on the brush, and then fully
clean the brush.
4. Reinstall the brush bushing, the brush, and the brush cover. It is
installed in place when you hear a "click" sound during brush cover
installation.
Brush Cover Clip
Brush Bushing
To Next Page