To Next PageTo Next Page
Need help?Do you have a question about the Xigmatek Air Killer Series and is the answer not in the manual?
General| Type | CPU Cooler |
|---|---|
| Connector | 4-Pin PWM |
| Product Name | Air Killer Series |
| Heatsink Material | Aluminum |
| Heatpipe | 4 x 6mm |
| Fan Dimensions | 120mm x 120mm x 25mm |
| Fan Speed | 800 - 1800 RPM |
| Bearing Type | Hydraulic Bearing |
Slide plastic clips to Intel LGA115x/1200 or 1700 backplate mounting holes.
Ensure screw bolts are locked in the backplate and install it to the motherboard.
Remove screws, bracket holders, and cooler base protective film.
Clean CPU, apply thermal paste, and install Intel cooler base mounting brackets.
Screw in spring screw pillars for cooler and motherboard installation.
Install cooling fan using included fan clips.
Remove screws, bracket holders, and cooler base protective film.
Clean CPU, apply thermal paste, and install AMD cooler base mounting brackets.
Screw in spring screw pillars for cooler and motherboard installation.
Install cooling fan using included fan clips.
Clip the cooling fan to the heatsink; repeat for a second fan for dual installation.
Connect the cooling fan's 4-pin PWM connector to the motherboard CPU Fan socket.
Connect the 3-pin ARGB connector to the motherboard for auto SYNC mode.
Connect the 3-pin ARGB connector to the Mini ARGB LED Controller for plug-and-play.
Press M button to switch between 9 different LED lighting effects.
Press S button to change LED speed across 5 available levels.
Hold S for 2 seconds to turn LEDs off; press M or C to turn them on.
Press C button to cycle through 7 different single LED colors.
Press S button to adjust LED brightness across 4 modes (single color mode).
