Xinje ZG3-30T - Page 44

SD1030
Wrong Pulse message
1：Pulse data block error
2 ： Equivalent mode ： pulse
amount/turn, amount/ turn of
movement is 0
3:Code of system parameters block
error
4: Pulse data block exceeds max
limit
10: Zero return do not set near point
signal
11：Speed of zero return is 0
12：Crawling speed of zero return is
0
13 Direction of zero return speed and
zero auxiliary speed
SD1031
Code of error pulse block
SD1040
Current segment(No. n segment)
PULSE_3
SD1041
SD1042
Low 16 bits of accumulated pulse
number (the unit is pulse number)
SD1043
High 16 bits of accumulated pulse
number (the unit is pulse number)
SD1044
Low 16 bits of accumulated pulse
number(the unit is pulse equivalent)
SD1045
High 16 bits of accumulated pulse
number(the unit is pulse equivalent)
SD1046
Low 16 bits of current output
frequency(the unit is pulse number)
SD1047
High 16 bits of current output
frequency(the unit is pulse number)
SD1048
Low 16 bits of current output
frequency(the unit is pulse equivalent)
SD1049
High 16 bits of current output
frequency(the unit is pulse
equivalent)
SD1050
Wrong Pulse message
1： Pulse data block error
2 ： Equivalent mode ： pulse
amount/turn 、 amount/ turn of
movement is 0
3:Code of system parameters block
error
4：Pulse data block exceeds max
limit